Cold Pulls

I finally have good prints happening again.

I picked up cleaning filament and printed about a foot of that. After some cold pulls with the cleaning filament, I’m doing cold pulls after every print.

I found I can still get a garbage print with PETG if I print a test batarang and immediately print something else without doing a cold pull.

This last print is looking perfect. (11 hours into a 33 hour print)

Original Prusa i3 MK3 kit

[Original Prusa i3 MK3 kit]


[Ultimate Troubleshooting Guide]


[V6 Assembly]

[9. Preflight check]

[firmware guide]

[drivers and downloads]




[How to fix the most common 3D printing errors]

[Help: Clogged nozzle]


[Extruder Slipping]

[Frequent Filament Jams]

[Printing from Fusion 360]

I replaced the [Y-Belt Idler]

[Printable Parts]

[SDK and Chroma]