Category: 3d Printing

[Silicone Socks]

[ORIGINAL PRUSA I3 MK3S AND MMU2S RELEASE, SL1 AND POWDER-COATED SHEETS UPDATE]

[MK3 to MK3S Upgrade Kit]

[Manual]

[Extruder]

[HOW TO PRINT WITH FLEXIBLE FILAMENT]

[forum question]

0.4mm Nozzle

Layer Height Min: 0.07mm (default)

Layer Height Max: 0.25mm (default)

Retraction Length: 0.8mm (default)

Retraction Lift Z: 0.6mm (default)

Minimum travel after retraction: 1mm (default)

[E3D V6 1.75mm x 0.4mm Nozzle]

[E3D V6 1.75mm x 0.8mm Nozzle]

[E3D V6 1.75mm x 1.0mm Nozzle]

• 

[Feature Request: Show Time Remaining]

Apparently [Slic3r] has this feature which exports with the gcode.

[HALLOWEEN 3D PRINTS SHOWCASE]

[Halloween extruder rotation visualizer]

I finally have good prints happening again.

I picked up cleaning filament and printed about a foot of that. After some cold pulls with the cleaning filament, I’m doing cold pulls after every print.

I found I can still get a garbage print with PETG if I print a test batarang and immediately print something else without doing a cold pull.

This last print is looking perfect. (11 hours into a 33 hour print)

INTRODUCING ORIGINAL PRUSA SL1 – OPEN SOURCE SLA 3D PRINTER BY JOSEF PRUSA

When adjusting the live-z setting for the MK3, this image is the first thing to compare.

[HOW TO FIX THE MOST COMMON 3D PRINTING ERRORS]

[thing:1568293]

[Original Prusa i3 MK3 kit]

[Materials]

[Ultimate Troubleshooting Guide]

[Manuals]

[V6 Assembly]

[9. Preflight check]

[firmware guide]

[drivers and downloads]

[firmware]

[forum]

[blog]

[How to fix the most common 3D printing errors]

[Help: Clogged nozzle]

[Callibration]

[Extruder Slipping]

[Frequent Filament Jams]

[Printing from Fusion 360]

I replaced the [Y-Belt Idler]

[Printable Parts]

[SDK and Chroma]

[Flexy-Hand 2]